Zoom Model 27 Instrukcja Operatora Pobierz pdf (Strona 11)

NOTE: The Model 6577 Telemetry Wand has been tested for 25 sterilization

cycles and more than this number o f sterilization cycles is not recommended.

Discardthewandanytimesurfacecrac

ks appea r in the plastic and/or the

cable discolors or becomes worn, regardless of the number of completed

sterilization cycles.

Make Wand and Cable Connections

For connector locations, re fer to

the illustrations of the PRM right side, left

side, and rear panels (Figure 1 on page 7, Fi gure 2 on pa ge 8, and Figure 3

on page 8).

1. Make the following connections on the rig ht side of the PRM.

[1] Antenna for ZIP telemetry [2] Stimulator inputs [3] Air intake [4] Analog output channel [5]

Telemetry wand connector [6] ECG connector

Figure 1. Right side p anel of the PRM

• Connect the telemetry wand to the tel emetry wand connector.

• Connect the Surface ECG Patient Cable to the ECG con nector. This

connection is electrically isolated. Attach the surface e lectrodes to the

patient i n a standard three-wire or ﬁve-wire conﬁguration.

NOTE: The ECG subsystem may be sensitive to high-frequency

ambient noise when the ECG inputs are not terminated.

NOTE: The ECG func tion is intended to be used during patient

exams for tests such as pace thr esh old testing with body-contacting

connections.

NOTE: The surface ECG traces may exhibit noise interference

if the PRM is in close proximity to high -frequency electrosurgical

equipment. For corrective action, re fer to the troubleshooting section

("Tr oubleshooting" on page 27).

• Connect a controller-stimulator cable to the PRM stimulator input

and then into the corresponding terminal on the e lectrical stimulation

source.

2. Make the f oll owi ng conne c ti ons on the left s ide of the PRM.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Brak uwag

Zoom Model 27 Instrukcja Operatora Strona 11